Loss of connection with ET200S

Dear friends,

I have managed to on-line with an CPU315-2 DP, which is a DP master, and has a slave ET200S (6ES7151-1AA04-0AB0).
And in the "Diagnostics" it showed a problem (see attached pic please).
What could be the problem?

Thank you in-advance.
Tomy

hello friend,

Here it is (see attached please).

Thank you again.

Tomy.

It should be actual module IM151 and software IM151 module (PLC program) are not the same type.

You should check both hardware catalog code first.

Best regards,

My friend,

In fact they are the same.

Tomy

Hello,

really hard to say exactly, my look point to not see version number of module, firmware. This can be first problem. Maybe another problem is (what I remember) add modules from not correct HW catalogue section. With PB DP there are more sections how to add modules, maybe specific GSD file of IM with also correct firmware can be added/attached, check our Forum for that specific GSD files but with correct firmware version (check modules side plate for sure). This is only what I see as primary, hope it's solution.

Update: sry to go better with solution, you had working ok your cfg before or problem is after init cfg?

DEAR FREINDS,

I would like to thank you all.
I have replaced the referred module with new one, and every thing now OK

Warm regards

Tomy 

Hello Tomy,

yes, in case your info will be also same version and fimware checked, then problem with module can be that reason probably  glad you have solved that.