Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

M commands with Jog mode

Created by: ozturkm at: 7/4/2013 9:20 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

7/4/2013 9:20 AM	Rate (0)
ozturkm Advanced Member Joined: 5/3/2013 Last visit: 3/20/2023 Posts: 49 Rating: (0)	I know that we can write theM commands in the MDI mode butcould we givethem in the Jog mode on the Sinumerik 810 GA3 system, is it possible? Best regards,

Suggestion To thank Quote Answer

7/4/2013 10:17 AM	Rate (0)
PISCEAN 2010 Diamond Expert Joined: 4/23/2010 Last visit: 3/21/2023 Posts: 8022 Rating: (855)	In JOG why you want to use M codes? Axes keys can be used for respective axes. In JOG mode axes motion cannot be contineous, its movementry, means axes will move till key is pressed.Do you have any specific requirement?

Suggestion To thank Quote Answer

7/4/2013 3:29 PM	Rate (0)
ozturkm Advanced Member Joined: 5/3/2013 Last visit: 3/20/2023 Posts: 49 Rating: (0)	You are right,i think this is specific application. We have a grinding machine which has two table.Ifwewant torotate first table to take the machine working position, we must write M64 ( this is the rotating command ) in the JOG mode. And we haven't any key to make it on the Sinumerik panel or some other place.Alsowe can see it in the PLC program. Best regards,

Suggestion To thank Quote Answer

7/4/2013 10:45 PM	Rate (0)
Pee El Sea Gold Member Joined: 1/19/2008 Last visit: 3/15/2023 Posts: 966 Rating: (58)	Hi, I think that you will find Overstore is available in Jog mode. This will do what you want Pee

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on