Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

MAG5000 error no.1

Created by: phyom at: 10/23/2011 6:04 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

10/23/2011 6:04 PM	Rate (0)
phyom Posts: 1 Rating: (0)	Hi all, After power black out all my MAG5000 LCD showed "power on" and inhibit all the time. I can't see flow reading anymore. I can't go to operator mode and programming mode too. According to MAG5000 user manual, it is error no.1. But user manual never show any remedy. I'd already tried to reset MAG5000 by holding "top up " key 2 sec before it power up. Yet the problem still persists. Thank you. Rgds, phyom
phyom Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

10/25/2011 2:49 PM	Rate (0)
DavieS Posts: 64 Rating: (2)	Sounds like the power outage damaged the transmitter. If you have any other mags in the plant can you swap transmitters to test?
DavieS Posts: 64 Rating: (2)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on