Navigation

Manual / Auto mode on BOP Parameter

Created by: J.A.T. at: 11/22/2018 12:39 AM (1 Replies)

11/22/2018 12:39 AM	Rate (0)
J.A.T. Advanced Member Joined: 11/1/2005 Last visit: 12/6/2024 Posts: 27 Rating: (0)	I have several Sinamics VFD's connected through Profinet to a S7-1500 CPU. My client has asked me to produce an alarm if a VFD is set to Manual Mode from the BOP. Is there a Parameter where i can see if the VFD is put into Manual Mode? Thank you

Suggestion To thank

11/22/2018 8:59 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (173)	Closed cause question posted twice. The second thread with the subject Manual / Auto mode on BOP Parameter is published within the conference SINAMICS. Best regards, Jen_Moderator

Suggestion To thank