Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Measuring linear encoder signal quality from within Sinumerik/Simodrive

Created by: rmb_cardoso at: 5/14/2013 10:19 AM (2 Replies)

Rating (0)

Thanks 2

3 Entries

5/14/2013 10:19 AM	Rate (0)
rmb_cardoso Bronze Member Joined: 4/28/2010 Last visit: 9/6/2024 Posts: 121 Rating: (0)	Hello, I would like to know if it is possible to check the quality of the linear encoder signal 1Vpp, the signal amplitude, signal quality, phase, position of the reference mark? In the case of absolute encoders is possible to know some diagnostics like for example the batery condicion etc. Is there any similar fucntion for incremental encoder? I know it is possible to check those signals using external devices, but it is necessary do disconect the encoder from the drive. Thanks in advance for your time, RC
	Last edited by: rmb_cardoso at: 5/14/2013 6:00 PM
Suggestion To thank Quote Answer

5/18/2013 2:13 PM	Rate (0)
CNC600 Silver Member Joined: 10/27/2009 Last visit: 3/15/2024 Posts: 455 Rating: (77)	Hi, there's an encoder diagnostic function available for SINUMERIK in coordination with SINAMICS. Activate this function via parameter p0496, diagnosis values in r0496/0497/0498/0499 available. You can trace these values by using TraceFunction at HMI-Operate, Trace from STARTER or put the values to the DAC and connect an external oscilloscope. For the provided diagnosis functions please refer to the documentation of SINAMICS (DOConWEB...) I don't know any similary diagnostic function at SIMODRIVE
	hope that helps CNC600
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users PISCEAN 2010 rmb_cardoso

7/17/2014 6:07 PM	Rate (0)
Narrator1 Bronze Member Joined: 3/25/2013 Last visit: 3/21/2019 Posts: 176 Rating: (1)	New question split intotransmit position signal from encoder to outside data aquisition system. With best regards, Narrator1

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on