Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Message associated values

Created by: RoH@ at: 1/23/2008 11:08 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

1/23/2008 11:08 AM	Rate (0)
RoH@ Posts: 14 Rating: (2)	Hello. I am trying to display associated values in our alarm control. We have a client-server project, PCS7 v6.1 and WinCC v6.0 sp3a HF 13. The problem is that all i get in the alarm control is a zero, (the assiciated value is an integer). When i run the OS-project in runtime on a stand alone machine everything works just fine, but out in the process with client-server the value always seems to be zero. Anybody that have had this problem? /Robert Attachment Message_3.jpg (81 Downloads)
RoH@ Posts: 14 Rating: (2)	Last edited by: RoH@ at: 23.01.2008 11:08
Suggestion To thank Quote Answer

1/23/2008 2:20 PM	Rate (0)
Ikkezelf Posts: 1084 Rating: (72)	Hi, Where is the tag located? On the client or on the server? Are you sure that you pinpointed to the correct location? with regards, Ikkezelf
Ikkezelf Posts: 1084 Rating: (72)
Suggestion To thank Quote Answer

1/23/2008 2:57 PM	Rate (0)
RoH@ Posts: 14 Rating: (2)	Hello The tag is located on the server, and in the event block in alarm logging i have written @4I%3d@. Attachment Message_2.jpg (77 Downloads)
RoH@ Posts: 14 Rating: (2)
Suggestion To thank Quote Answer

1/23/2008 3:38 PM	Rate (0)
Ikkezelf Posts: 1084 Rating: (72)	If you open the properties of that alarm in the alarm logging, you will normally see the details of that connected process tag. Hopefully the same within pcs7, cause i have never used that before. Please have a look if this tag is pointing to the correct tag etc. sorry don;t have wincc installed here atthe moment. When you look at the tag on the server when the alarm is initiated you are sure there is a value in other then zero? (you can hover over the tag to see it's runtime value) with regards, ikkezelf
Ikkezelf Posts: 1084 Rating: (72)
Suggestion To thank Quote Answer

9/29/2008 11:20 AM	Rate (0)
Stalker Posts: 8 Rating: (0)	RoH@ Hello The tag is located on the server, and in the event block in alarm logging i have written @4I%3d@. May be you should try @4W%3d@ Also try to add Process Parameter 4 into Alarm Control and watch it's actual value
Stalker Posts: 8 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on