Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Message did not reset

Created by: crown cement at: 8/23/2020 8:14 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

8/23/2020 8:14 AM	Rate (0)
crown cement Posts: 2 Rating: (0)	Input protection fault message showing of siemens perfect harmony drive gen iv. this message did not reset. According to manual checked one by one but message did not reset. please suggest me. ------------------------------------------------------------------------------------------ Split from Input protection fault.
crown cement Posts: 2 Rating: (0)	Last edited by: Jen_Moderator at: 08/24/2020 10:41:38 New subject after splitting
Suggestion To thank Quote Answer

8/23/2020 8:45 AM	Rate (0)
JKV JAMES ❤️(Köni... Silver Member Joined: 12/27/2018 Last visit: 10/2/2024 Posts: 510 Rating: (43)	We have faced similar issue and looking for solutions.Also many Drives in plant triped frequently.But normal when reset but trip again after some time too. NXG firmware updated to latest one and monitoring same.Is there any batch issue with these products?
	Jinson James, M.Tech (Power Electronics and Power System),
Suggestion To thank Quote Answer

8/23/2020 9:48 AM	Rate (0)
crown cement Posts: 2 Rating: (0)	There are no batch issue with these products. Stop condition suddenly this message show "Input protection fault". Normally this message is reset. But not being reset now.
crown cement Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on