Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Migration from Op17 to Op177B with Simatic S7-NC

Created by: Sulung at: 4/1/2009 12:36 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/1/2009 12:36 PM	Rate (0)
Sulung Bronze Member Joined: 5/26/2007 Last visit: 9/30/2023 Posts: 126 Rating: (3)	I have a S7 300 plc with fm357 system. the HMI was OP17. it was broken. since the OP17 is no longer available i change to OP177B. i have the OP17 source program. 1. The problem is winCC flex does not support simatic-NC. so i could not do auto migration. what i need to do? 2. i attach OP17_tag.jpg. i open my op17 source file, when i click on one of the simatic -NC tag i have a message : C:\protool\NC_Var.mdb could not find this file what i intend to do is i need to know how do i access this tag address if rebuild everything with winCC flex. thanks in advance Attachment OP17_tag.JPG (86 Downloads)

Suggestion To thank Quote Answer

4/1/2009 1:14 PM	Rate (0)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 7/12/2023 Posts: 10221 Rating: (1177)	Hello sulung, Have you seen in manual SIMATIC HMI WinCC flexible 2008 Migration (from page 177) Hope this will helps. Best regards

Suggestion To thank Quote Answer

4/2/2009 6:12 AM	Rate (0)
Sulung Bronze Member Joined: 5/26/2007 Last visit: 9/30/2023 Posts: 126 Rating: (3)	dear Umencho, thanks for your help. yes i have read the manual. in page 179, migration from simatic s7-nc plc, an error message will be issue and migration will be aborted. but in page 165, NC function replaced with sinumerik option. i do not understand what is the meaning of sinumerik option. i need to know where to look for the NC tag address, may be i add some program in plc to read this nc address and put it in a DB for OP177B to access it.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on