Module configured, but not available. S120 drive

Hello,

I am an absolute beginner in the world of PLCs. I am trying to commission a S120 drive using the PLC program.
I have commissioned the drive using SIMOTION SCOUT software. I am able to control the drive using this software.
However, when I try to do the same using just S7, I find that in the hardware configuration I get a message saying "Module configured, but not available".

Can anyone kindly help me? What do you think the problem is? I am an absolute beginner and there might be many things I have missed. I am attaching a few screenshots to give you a better picture of the problem I face.

Cheers!

Hello,

check the NameofStation and the port interconnection (if you configured it in the project)

Regards

Christoph

HI Christoph,

The NamesofStation and the port addresses are as configured in the project.

I downloaded the configuration again and restarted the system yet there is no change.

Do you know what might be the cause?

Hello,

can you go online to the drive in Scout?
Any Fault or Warning present?

The IP is set Correctly on the S120?

Can you start Edit Ethernet nodes in Simatic and take ascreen of the devices which are found?

Teh telegram configuration in the project is the same like in the Drive Configuration in Scout?

Regards
Christoph

Hi Christoph,

Yes, I can go online using Simotion Scout without any problem. I have commissioned the drives using Scout. I took control priority and Scout and controlled the rpm, jog etc.

There are no warnings or faults when I use SCOUT.

Yes, I have used Profisafe Telegram 30 and Siemens Telegram 110. Both are same on the Scout and in the project.

The IP address I am using for the PLC is 192.168.0.1 and for the drive I am using 192.168.0.6. here are the screenshots.

Regards,

Gaurav