Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

module replacement at online in ET200s

Created by: vinot at: 3/12/2009 1:15 PM (5 Replies)

Rating (0)

Thanks 1

6 Entries

3/12/2009 1:15 PM	Rate (0)
vinot Posts: 18 Rating: (0)	Hi to all What is the procedure for replacing the modules at online in ET200s and how can i check whethere it is working or not. please provide your valuable suggestions to rectify my problem. Regards Vinot
vinot Posts: 18 Rating: (0)
Suggestion To thank Quote Answer

3/12/2009 4:28 PM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 6/5/2023 Posts: 8587 Rating: (1127)	Dear vinot, Have you seen this thread: /tf/WW/en/Posts/22785 Perhaps it's useful Best regards, Wizard

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users vinot

3/13/2009 4:25 PM	Rate (0)
Eastern Posts: 557 Rating: (64)	hi in simatic manager ---go to hardware configuration --put thehardware configuration online & check all modules are ok or not. if modules are not ok then in module information you will get the message module configured not avaible. following possibility a) module faulty(hardware problem)(check connection & 24v ok or not) b) hardware configuration having a problem(wrong hardware download)(software problem) if module is not ok you can change modules online.but put all other ob's before change the module online FOLLOWING OB's are required OB122,OB80,OB85,OB86,OB87 Regards
Eastern Posts: 557 Rating: (64)
Suggestion To thank Quote Answer

3/13/2009 5:18 PM	Rate (0)
Denilson Pegaia Platinum Member Joined: 9/23/2005 Last visit: 6/5/2023 Posts: 4184 Rating: (1342)	Hi, Important Tip: exchange just one module per time. If more then one module is missing or fault, it could be possible that all ET200S goes to fault mode.
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

3/14/2009 4:54 AM	Rate (0)
Eastern Posts: 557 Rating: (64)	HI YES i am also agree with this. see this link you required following setting before remove the online module. /tf/WW/en/Posts/27411#128660 regards
Eastern Posts: 557 Rating: (64)
Suggestion To thank Quote Answer

3/14/2009 1:48 PM	Rate (0)
vinot Posts: 18 Rating: (0)	Hi to all My problem was cleared. Thaku you so much to Wizard, Vivek and Pegaia. Regards Vinot
vinot Posts: 18 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on