Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

MY CCU3 UNIT SHOWS 3 IN DISPLAY AND ALL LEDS LIT

Created by: Jhon Ford at: 7/5/2013 7:33 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

7/5/2013 7:33 PM	Rate (0)
Jhon Ford Posts: 1 Rating: (0)	Dear Viewers, My lathe has Sinumerik 810D, my CCU3 unitstuck and shows only 3 on 7segnment display and all the leds lights on so many times i do the NC and PLC clearing proceture but display shows 3. Any one help me i will appriciate and thanks in advance, I am waiting for help. Jhon Ford.
Jhon Ford Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

7/6/2013 3:55 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	Hello, It Could be problem with the CCU card....may be power section is defect inside... Try replacing it and check it will work... For more informations... /tf/WW/en/Posts/42983#top Regards, Prakash
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on