Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

NC start without referencing 1 axis in the machine

Created by: ŠΜS at: 10/21/2010 5:04 PM (3 Replies)

Rating (0)

Thanks 2

4 Entries

10/21/2010 5:04 PM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 2/3/2023 Posts: 569 Rating: (37)	Hi, In 840D controlled machine,I need to run the part program with out referencing only one axis of the machine.Other axis should be referenced.Incremental encoder is used for all the axis.MD20700 is for all the axis, Is there any parmeter/DB signal for single axis of the Machine? Regards, Muthamizh
	Last edited by: Muthamizh Selvan at: 10/21/2010 5:05 PM Regards, ŠΜS
Suggestion To thank Quote Answer

10/22/2010 7:11 PM	Rate (0)
SteveA Posts: 297 Rating: (41)	You can set parameter MD 34110 REFP_CYCLE_NR to -1 for any axis and it will not need to be referenced to run a program. HTH, SteveA
SteveA Posts: 297 Rating: (41)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users ŠΜS

10/23/2010 1:13 PM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 2/3/2023 Posts: 569 Rating: (37)	Dear Steve, Wheather it is possible to change this parameter through PLC? If yes how? Regards, Muthamizh
	Regards, ŠΜS
Suggestion To thank Quote Answer

10/26/2010 7:07 PM	Rate (0)
SteveA Posts: 297 Rating: (41)	I think you could change the parameter using FB3, but if you looked at Doc on CD, it shows that changes to that parameter do not take effect until after a PowerOn (NCK Reset). So sorry, it is not possible to change this while the machine is running. SteveA
SteveA Posts: 297 Rating: (41)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users ŠΜS

|

Share this page:

Share this page on...

Follow us on