Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

NCK address

Created by: 13kem at: 12/1/2010 5:10 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

12/1/2010 5:10 PM	Rate (0)
13kem Posts: 2 Rating: (0)	Hi, How can I change the NCK address on the OPI bus? Configuration: 840D - pl MMC103 OP030 The original address of the machine is 2on theOPI bus. Thanks
13kem Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

12/1/2010 5:40 PM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	13kem Hi, How can I change the NCK address on the OPI bus? Configuration: 840D - pl MMC103 OP030 The original address of the machine is 2on theOPI bus. Thanks Hello..... You can change the NCK address on the OPI bus..... goto startup_hmi_opi_ but where you have plugged the MPI cable on the NCU card X122 / X101 ? If you have plugged the cable on X122 (baudrate 187.5kbps) the address of the NCK=3, PLC=2, MMC=1,PC/Pg=0 Ifyouhave plugged the cable on X101(baudrate 1.5Mbps) the address of the NCK=13,PLC=13, MMC=1,PC/PG=0 check it out.... Regards,
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

12/2/2010 7:30 AM	Rate (0)
13kem Posts: 2 Rating: (0)	Hi, I have plugged the cable on X101. On the OPI-bus, the address of the NCK=13 and I need to change the NCK=2 to restore the original configuration of the machine. Thanks
13kem Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on