manudomgar

Thank you!

It worked!!! Again you helped me :)

manudomgar

FC50 takes the same memory.

manudomgar

Name: NewG
Scan rate: 1 (don't know meaning, default option)
Phase offset: 0 (don't know meaning, default option)
Optimize run sequence: Active (don't know meaning, default option)
Active: Active (don't know meaning, default option)

manudomgar

The same as the one on the beginning, so perfect :)
....
But I don not understand... OB100 is the same everytime; just a call to FC50, and I couldn't find any difference in FC50 from the one at the begining to the one at the end... where is the inicialization of my new 40 AI?

If you really want to make it perfect you can bring all blocks from user CFC into groups. So in general all blocks except the blocks OB_BEGIN, OB_END and PO_UPDATE. The mentioned blocks could also be in groups but it is easier to locate them if there are outside the groups because OB_BEGIN should always be the first and OB_END and PO_UPDATE the last blocks of an OB. You should know that CFC is generating a FC from every group and than another FC for everything wich has to be called in an OB. So if you create groups the compiler starts for every group from the beginning and that makes it unlikely that the code limit is reached.Now for the group for 'everything wich has to be called in that OB' only the FCs for the groups have to be called.
In before you had no (or only a few) groups. In that case everything is compiled in the 'OB-FC' (in your case FC50)
Maybe my explaiation is not so good, but trust me; Your compilation and download of changes will be much faster (if a block is affeceted in this changewich is included in OB100) if you create groups for nearly all blocks of OB100 !!!
I would put 10-40 blocks in each group of OB100
Regards...

Update regarding V8.1 and V8.2 and higher:

From 8.1 on you should mange your groups in OB100 like in the cyclic tasks (OB3x), that means to have a Group for each CFC in OB100, too. This is necessary for compilation and download of cahnges of single charts. If you upgrade a project to V8.1 it will be a huge job to make this modifications to the OB100, if you want the possibility of download of single charts also for the existing CFCs. From V8.2 there is a functionality included in PCS7 by wich you can perform the job of creating the groups and sorting the blocks automatically.

Of course from V8.1 on groups for new CFCs are created for each CFC also in OB100 anyway when creating new CFCs from the scrap on. But if you have a project library from wich your CFCs are generated, modify your library to that new concept before creating instances from that library.