Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

OLE alarm

Created by: peters at: 1/18/2007 8:02 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

1/18/2007 8:02 AM	Rate (0)
peters Posts: 122 Rating: (4)	dear experts: when i click the "alarm" button on the "WINCC RUNTIME","OLE-control1" will come out(see the document),i don't know why. Attachment OLE.zip (177 Downloads)
peters Posts: 122 Rating: (4)
Suggestion To thank Quote Answer

1/18/2007 9:34 AM	Rate (0)
Nemo Posts: 3149 Rating: (171)	Hi which WinCC version are you using? Does this happen in a new WinCC project as well? Could you please post the WinCC log files? Which other software is installed on your PC? Did you install WinCC as thelast software? Please check in "Graphics Designer > Object palette > reg. OCX" whether your AlarmOCX ist registered nemo
Nemo Posts: 3149 Rating: (171)	Last edited by: Nemo at: 1/18/2007 9:37 AM
Suggestion To thank Quote Answer

1/29/2007 7:16 AM	Rate (0)
Raheel Bronze Member Joined: 8/10/2006 Last visit: 7/15/2024 Posts: 156 Rating: (3)	I agree with Nemo, In graphic designer, open this picture and on the right hand side there is a controls window. Check whether WinCC alarm control is there, if not then right click and try to add this control (if the ocx component is registered then it wud display it there). After adding you have to draw the window again. Regards, Raheel
	Last edited by: Raheel at: 1/29/2007 7:18 AM
Suggestion To thank Quote Answer

1/29/2007 2:05 PM	Rate (0)
Danielle Posts: 1275 Rating: (123)	I've seen problems like this when an user opened an application saved under WinCC v6.0 SP4 on a machine which had v6.o SP3. If that's not the case, make sure there are no compatibility problems, and, as Nemo mentioned, your OCX is properly registered. Did this control work before?
Danielle Posts: 1275 Rating: (123)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on