Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Online download to a S71200 CPU without the CPU going to STOP???

Created by: LKC at: 5/15/2012 11:41 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

5/15/2012 11:41 AM	Rate (0)
LKC Posts: 23 Rating: (0)	I'm using the TIA portal V11 and a 1214C CPU firmware V2 ...every time I download a change I have made to my program to my CPU, the CPU goes to STOP and then back to RUN again which is fine as long as the CPU is on my desk in here at the office... ...but once the CPU is installed in the field i would like it to be able to accept changes without going to STOP since its outputs and inputs will be connected to other equipment which i want to continue working normaly when I make changes to my program... ...so, is it possible to download to the S7 1200 CPU without the CPU going to STOP mode?
LKC Posts: 23 Rating: (0)
Suggestion To thank Quote Answer

5/15/2012 12:53 PM	Rate (0)
Gabriel de Oliveira Bronze Member Joined: 2/16/2011 Last visit: 1/13/2025 Posts: 229 Rating: (28)	Hello, It's possible if you have TIA V11 SP2 or later and cpu's Firmware v2.2 or later. Regards
	Gabriel de Oliveira It Works? Rate It.
Suggestion To thank Quote Answer

5/15/2012 5:03 PM	Rate (0)
0_Einstein Diamond Expert Joined: 7/7/2010 Last visit: 1/16/2025 Posts: 15541 Rating: (2465)	LKC ...so, is it possible to download to the S7 1200 CPU without the CPU going to STOP mode? As Gabriel stated for the min requirements to have download in run, here's linkto anotherthread here on what you can do without requiring a STOP of the PLC. /tf/WW/en/Posts/69023
	science guy
Suggestion To thank Quote Answer

5/15/2012 5:35 PM	Rate (0)
JJJ Posts: 39 Rating: (1)	Gabriel de Oliveira Hello, It's possible if you have TIA V11 SP2 or later and cpu's Firmware v2.2 or later. Regards Hello, With, TIA V10.5it is notpossible? or minimum V11is required? becausewe don't have V11withour companyand we just need to know the possibility.
JJJ Posts: 39 Rating: (1)
Suggestion To thank Quote Answer

5/15/2012 6:17 PM	Rate (0)
0_Einstein Diamond Expert Joined: 7/7/2010 Last visit: 1/16/2025 Posts: 15541 Rating: (2465)	Gabriel de Oliveira Hello, It's possible if you have TIA V11 SP2 or later and cpu's Firmware v2.2 or later. Regards This quoted statement is 100% correct. That is the absolute minimum for the S7-1200 PLCs.
	science guy
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on