Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

OP 270 - older panel in portal

Created by: burlecus at: 3/27/2014 2:41 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

3/27/2014 2:41 PM	Rate (0)
burlecus Regular Member Joined: 5/25/2009 Last visit: 9/12/2024 Posts: 18 Rating: (2)	Hello. I have a quickie. I converted a project from S7 into portal V12, it had a 315-PN/DP and an OP270. When converted, it had put a OP277, it looks the same but it also has PROFINET and stuff. Some modules and OP's are not supported. But for the CPU, for instance, even if it pust another code there and the HW config is always showing a problem, it does compile and you can transfer your stuff in and work. For the OP it does not seem to work, it knows that the OP is not what you have in your project and refuses to transfer. Any suggestions, aside of staying back in good'ol Step7? Thanks.

Suggestion To thank Quote Answer

3/27/2014 8:55 PM	Rate (0)
IBN-Service Posts: 8946 Rating: (999)	OP 270 is not supported by TIA. Use Step7 V5.5 with WinCCflex2008 or change to other paneltype.
IBN-Service Posts: 8946 Rating: (999)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on