Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

PB with CTRL_HSC

Created by: TheMax at: 2/1/2013 11:07 AM (2 Replies)

Rating (0)

Thanks 1

3 Entries

2/1/2013 11:07 AM	Rate (0)
TheMax Posts: 15 Rating: (0)	Hi, I have a problem with CTRL_HSC, I have a status 80D0, whereas before this counter was ok. I did'nt change my program on this part, and and I did'nt find this error on the help. Thx for the help. Cordialy Maxime BERNARD Attachment counter.JPG (134 Downloads)
TheMax Posts: 15 Rating: (0)	Last edited by: TheMax at: 2/1/2013 11:20 AM
Suggestion To thank Quote Answer

2/4/2013 10:34 AM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 12/8/2023 Posts: 4284 Rating: (1380)	Hi, This error code has the follow description on the manual: 80D0 High-speed counter (HSC) not enabled in CPU hardware configuration Please check if 1 - if it has enabled -> your HW device - > CPU properties -> High speed counters (HSC) (remember to compile the HW) 2 - if you place in HSC block the right name of the HSC
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users AutoGen_5218103

7/30/2014 1:50 PM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 11/23/2023 Posts: 2683 Rating: (135)	New question was split to CTRL_HSC status 80D0 if i load the program on a SD card. Best regards O_Moderaot
	Tips&Tricks for the forum usage
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on