Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

PG Communication

Created by: Rippe at: 6/16/2009 7:26 PM (6 Replies)

Rating (0)

Thanks 0

7 Entries

6/16/2009 7:26 PM	Rate (0)
Rippe Posts: 2 Rating: (0)	Hi all Here's my guestion: What protocol PG communication uses when communicating with CPU. Is it some sort of S7 communication? Thanks
Rippe Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

6/16/2009 7:58 PM	Rate (0)
Darius Platinum Member Joined: 9/28/2005 Last visit: 11/6/2023 Posts: 2957 Rating: (242)	Hello, I can't tell you for sure, but I think it's some kind of special communication. If you look at CP in online mode then you will see how much utilized S7 connections, how much basic connections and so on. One type of communications there is PG communications. So I think it might be some special case of comms. To use S7 communication you should set it up in NetPro, but you don't need to setup anything to connect from PG or SCADA PC. I may be wrong, but I think its special type of protocol with support of breakpoints and so on.
	Best regards, Darius
Suggestion To thank Quote Answer

6/16/2009 8:00 PM	Rate (0)
UMENCHO Diamond Expert Joined: 3/21/2006 Last visit: 11/14/2023 Posts: 10222 Rating: (1177)	Hello Rippe, For me it's not so clear your question. What did you mean with PG communications? Give more details about your issue. regards Hristo Mihalev

Suggestion To thank Quote Answer

6/16/2009 8:07 PM	Rate (0)
Darius Platinum Member Joined: 9/28/2005 Last visit: 11/6/2023 Posts: 2957 Rating: (242)	Hi, UMENCHO I think he wanted to know what protocol Step7 (WinCC)uses to communicate to PLC. At least I understood question like this.
	Best regards, Darius
Suggestion To thank Quote Answer

6/16/2009 8:46 PM	Rate (0)
Rippe Posts: 2 Rating: (0)	Hi Darius You get my point exactly.
Rippe Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

6/16/2009 8:48 PM	Rate (0)
UMENCHO Diamond Expert Joined: 3/21/2006 Last visit: 11/14/2023 Posts: 10222 Rating: (1177)	Hi Darius, You might be right. . Basically communication between PLC and SCADA system, the easiest way is via OPC Server. And here we could find a lot examples using SimaticNet OPC server and some type of S7 communication. (MPI, Ehternet or Profibus). And for this is better to have more details... Regards Hristo Mihalev

Suggestion To thank Quote Answer

6/16/2009 9:15 PM	Rate (0)
Darius Platinum Member Joined: 9/28/2005 Last visit: 11/6/2023 Posts: 2957 Rating: (242)	OPC is ok, but the main question is what protocol is used when you monitor PLC from your PG. Is it S7 communication ? I don't think so, I think this is some kind of special communication with special abbilities. How do you think ?
	Best regards, Darius
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on