HELLO EXPERT,

I M USING PID COMPACT IN WINCC TIA PORTAL V12 SP1 WITH 1200 CPU BUT THER IS PROBLEM AUTO/MANUAL MODE SELECT AND OPERATION RELATED ISUE.

REGARD

JESH

Jesh

HELLO EXPERT,

I M USING PID COMPACT IN WINCC TIA PORTAL V12 SP1 WITH 1200 CPU BUT THER IS PROBLEM AUTO/MANUAL MODE SELECT AND OPERATION RELATED ISUE.

REGARD

JESH

Hello,

Is it possible for you to change mode of operation of PID Compact via a watch-table in TIA Portal?If you could do that without problem, did you use same commands via WinCC ?

Best regards,

hdhosseini

THANKS hdhossioni,

I APPERECIATE YOUR RESPONCE BUT EXACT PROBLEM IS I SELECT MANUL MODE FROM SCADA AND GIVE SP =100% THEN OUTPUT IS 100% IF I CHANGEOVER IN AUTO MODE THEN OUT PUT DOES NOT CHANGE AND ITS BEHAIVE AS MANUAL MODE 

PLEASE GIVE ANY SOLUTION

IF I CHANGE OVER AUTO/MANUAL MODE AND GET RESPONCES AS WHICH MODE IS SELECTED IN SCADA.

REGARD

JESH