Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

PLC npt started up

Created by: bimi at: 5/22/2010 11:37 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

5/22/2010 11:37 AM	Rate (0)
bimi Posts: 1 Rating: (0)	I have a Breton CNC machine and recently chaned the NCK battery but now when I start the machine get the alarm 2001 PLC not started up. Any help would be appreciated. many thanks, Bimi
bimi Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

5/25/2010 11:14 AM	Rate (0)
makaveli Posts: 259 Rating: (5)	When you changing battery your machine was tour on? I think you don’t have PLC program in NCU. So you must restore your PLC backup.
makaveli Posts: 259 Rating: (5)
Suggestion To thank Quote Answer

5/25/2010 1:16 PM	Rate (0)
Ekalavya Posts: 2964 Rating: (473)	bimi I have a Breton CNC machine and recently chaned the NCK battery but now when I start the machine get the alarm 2001 PLC not started up. Any help would be appreciated. many thanks, Bimi Hi.... Could you Check any other alarms are present in the machine. If i understand you need to load the NC-PLC backups rpk89
Ekalavya Posts: 2964 Rating: (473)
Suggestion To thank Quote Answer

5/26/2010 11:56 AM	Rate (0)
OvidiuNastac Silver Member Joined: 1/29/2008 Last visit: 7/26/2022 Posts: 419 Rating: (19)	Hi First of all what type of system do you have on the machine? Nit

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on