Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Please help

Created by: thanhngo at: 12/16/2010 6:37 AM (7 Replies)

Rating (0)

Thanks 0

8 Entries

12/16/2010 6:37 AM	Rate (0)
thanhngo Posts: 10 Rating: (1)	Hi all. I had a hyundai HiT-8S with Seimens 840c control. - Machine power up, Boot up O.K with No alarm, but can not pushing green button for get Power On.Thanks
thanhngo Posts: 10 Rating: (1)
Suggestion To thank Quote Answer

12/16/2010 1:20 PM	Rate (0)
echtzeit Posts: 1 Rating: (0)	No replies. m-m-m. Interesting. Mda ... Not interesting. Сheck circuit. Good luck.
echtzeit Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

12/16/2010 6:22 PM	Rate (0)
Gebhardt Karl Platinum Expert Joined: 7/16/2006 Last visit: 1/2/2024 Posts: 1502 Rating: (176)	Hi >Machine power up, Boot up O.K > with No alarm, No Alarm, normaly he say as example, you have no "Refpoints . . " or other Alarms. >but can not pushing green button for get Power On O.K. Please check, if the PLC-Programm is working. Check, if a PLC-output is set. Turn you Mainswich ON. Check the 9 Voltage Batterie of your unit. (Dont remove the Batterie ! ! !) How many voltage do you have ?
	Karl
Suggestion To thank Quote Answer

12/17/2010 3:37 AM	Rate (0)
thanhngo Posts: 10 Rating: (1)	Please show me how to reload the PLC program and also how to re_set the PLC-output ( Checked showing no light on all output)Thanks
thanhngo Posts: 10 Rating: (1)
Suggestion To thank Quote Answer

12/17/2010 10:37 AM	Rate (0)
OvidiuNastac Silver Member Joined: 1/29/2008 Last visit: 7/26/2022 Posts: 419 Rating: (19)	Hi Did you checked the hardware limit switches? Godd luck Nit

Suggestion To thank Quote Answer

12/17/2010 12:07 PM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	thanhngo Please show me how to reload the PLC program and also how to re_set the PLC-output ( Checked showing no light on all output)Thanks Hello.... Please find the attachment.... Regards, Ekalavya Attachment PLC GEN RESET Procedure.pdf (120 Downloads)
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

12/23/2010 7:48 AM	Rate (0)
thanhngo Posts: 10 Rating: (1)	ANW_PROG file is empty, How I reload or re_program it back?Please help
thanhngo Posts: 10 Rating: (1)
Suggestion To thank Quote Answer

12/23/2010 6:22 PM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	Hello.... You canreload the ANW_PROG file through FX software..... If you have backup in Step5 fromat try to load the same Re-programming can be done through STEP5... Re-programming becomes like another full commissioing the machine.... Best way is to check out from the machine manufacturer OEMthey will be having this backup... Regards, Ekalavya
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on