Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

problem in startup Siemens 810M

Created by: A.Pasandi at: 8/6/2011 8:17 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

8/6/2011 8:17 PM	Rate (0)
A.Pasandi Experienced Member Joined: 12/22/2010 Last visit: 3/17/2023 Posts: 95 Rating: (0)	Hi, I have 1set sinumerik 810M GA3 SW:3 this system after power on and start NC on pushbutton not woked and none LED's not worked course, monitor on Sinumerik not work(monitor is off) I test power supply and monitor to another system control. please help! I push the EYE key andpush the NC on sorry system control don't normaly work I start system control this morning by EYE key afte a few sec send message in monitor i attached in this page Initializing interface board... interface board not found!!! Best regards Attachment IMAG0228.jpg (81 Downloads)
	Last edited by: A.Pasandi at: 8/7/2011 6:44 PM Last edited by: A.Pasandi at: 8/7/2011 6:40 PM Last edited by: A.Pasandi at: 8/6/2011 8:19 PM
Suggestion To thank Quote Answer

8/7/2011 7:39 PM	Rate (0)
Ekalavya Posts: 2964 Rating: (473)	Looks like your NC CPU board is defect check the Eproms mounted in this ......remove and plug it back.... Regards, Prakash
Ekalavya Posts: 2964 Rating: (473)	Last edited by: Ekalavya at: 8/7/2011 7:40 PM
Suggestion To thank Quote Answer

8/24/2011 5:53 PM	Rate (0)
dsf1 Posts: 2 Rating: (0)	I hawe the some problem. What is the solution ?
dsf1 Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

5/28/2018 9:18 AM	Rate (0)
Jen_Moderator Moderator Joined: 6/19/2017 Last visit: 3/27/2023 Posts: 6658 Rating: (130)	New question published by Masoo is split to a separate thread with the subject problem in startup Siemens 810M: Monitor don't take power.. Best regards Jen_Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards Jen_Moderator
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on