Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Problem using basic objects on screens

Created by: Drao at: 7/30/2013 5:54 PM (4 Replies)

Rating (0)

Thanks 3

5 Entries

7/30/2013 5:54 PM	Rate (0)
Drao Posts: 3 Rating: (0)	Hi, I have a strange problem with a Wincc Professional project in TIA Portal V11. When I have already developed some 30 screens and use approximately 600 variables, not on the screen to enter basic type objects such as circles, rectangles, lines, etc.. If I do, when compiling I get the message: "There were errors and the application needs to close. Do you want to restart the application? " But if I may introduce other elements such as buttons, sliders, gauges, etc..without causing errors. In other different projects do not happen this problem. This error has me quite confused. Can anyone give me any suggestions to fix it? Thanks and regards
Drao Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

7/31/2013 6:21 AM	Rate (0)
Nelliyan randy Posts: 461 Rating: (29)	do u see any pop up like in image .. Attachment error.JPG (354 Downloads)
Nelliyan randy Posts: 461 Rating: (29)
Suggestion To thank Quote Answer

7/31/2013 8:21 AM	Rate (0)
Drao Posts: 3 Rating: (0)	That is exactly the message. thanks
Drao Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

7/31/2013 8:23 AM	Rate (0)
Nelliyan randy Posts: 461 Rating: (29)	Then this can be a solution check the link 4 th post /tf/WW/en/Posts/95723#top regards, Nelliyan.G
Nelliyan randy Posts: 461 Rating: (29)	Last edited by: Nelliyan randy at: 7/31/2013 8:24 AM
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Drao

7/31/2013 10:46 AM	Rate (0)
Drao Posts: 3 Rating: (0)	Hi, I used the option to open two windows of TIA PORTAL and copy the entire project into a new one, drag and drop. Then, as the post said to compile the project again the error appeared. In my case, for some reason unknown to it had broken the link between HMI and PLC. Rebind After the error has disappeared. Thank you very much to all for your time. I hope I can help you sometime. Regards.
Drao Posts: 3 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users O_Moderator Nelliyan randy

|

Share this page:

Share this page on...

Related topics by keywords:

TIA WinCC Adv Picture Controls

Follow us on