Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Problem with 802dsl startup

Created by: Lukasq25 at: 5/18/2010 1:04 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

5/18/2010 1:04 PM	Rate (0)
Lukasq25 Posts: 2 Rating: (0)	Hi I have a little problem, I try to start up the milling machine with 802Dsl with sinamics drives In MD/Drive MD i have CU-0 ready ALM-0 Ready but all drives shows me 43 ( [42]-set on/off3-"1" (p0848, p0849) Is this problem made by PLC or signals in CU? I had to set the checkback signal time from line contactor in ALM to 200ms becouse on 100 it didnt hold me the LC in ON state. I have made it by topology and only set the time and line contactor button on. Have i to made anything more?? I would be gratefull for fast help Greatings Lukas
Lukasq25 Posts: 2 Rating: (0)	Last edited by: Lukasq25 at: 5/18/2010 2:04 PM omg iam little dummy today hyhy i made some proces in this i simply didnt set the MD 30130 but now have next problem it dont enable the servo now i have status 31 that says ready to set -set on/off1 on 1 p0840 Last edited by: Lukasq25 at: 5/18/2010 1:09 PM Forgot next thing in serve the parameters 848 is 137034754 and 849 is 47318017 Last edited by: Lukasq25 at: 5/18/2010 1:05 PM P.S in servo parameters in p0046 i have 1073749007
Suggestion To thank Quote Answer

6/7/2010 4:23 PM	Rate (0)
pfuser Silver Member Joined: 9/18/2006 Last visit: 3/19/2023 Posts: 583 Rating: (64)	Hi. Probably it will help you. https://www.automation.siemens.com/tf/WW/en/Posts/40681#top Best regards.
	Last edited by: pfuser at: 6/7/2010 4:24 PM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on