Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Problem with debugging – can’t set a breakpoint

Created by: dejanH at: 11/25/2008 6:42 PM (5 Replies)

Rating (1)

Thanks 0

6 Entries

11/25/2008 6:42 PM	Rate (0)
dejanH Posts: 32 Rating: (0)	Hi all, I would like to set a breakpoint when I debug my application, but all controls corresponding with breakpoints in STL editor are disabled. I did all settings as help recommends, including setting Operation mode to “Test operation”. Any ideas what’s the problem? Thanks in advance.
dejanH Posts: 32 Rating: (0)
Suggestion To thank Quote Answer

11/25/2008 7:37 PM	Rate (1)
Tomcat Posts: 433 Rating: (48)	Hi dejanH, do you opened the block in online mode? Go to "File" -> "Open Online". Then the buttons should be enabled. Tomcat
Tomcat Posts: 433 Rating: (48)
Suggestion To thank Quote Answer

11/25/2008 7:59 PM	Rate (0)
dejanH Posts: 32 Rating: (0)	Thanks for your answer, Iclicked "File" -> "Open Online and everything works.
dejanH Posts: 32 Rating: (0)
Suggestion To thank Quote Answer

11/25/2008 8:43 PM	Rate (0)
Tomcat Posts: 433 Rating: (48)	Fine!
Tomcat Posts: 433 Rating: (48)
Suggestion To thank Quote Answer

6/11/2014 1:03 PM	Rate (0)
Narrator1 Bronze Member Joined: 3/25/2013 Last visit: 3/21/2019 Posts: 177 Rating: (1)	Question split into topicset a breakpoint - button Set/Delete breakpoint is grey. With best regards, Narrator1

Suggestion To thank Quote Answer

4/26/2018 11:48 AM	Rate (0)
Jen_Moderator Moderator Joined: 6/19/2017 Last visit: 6/5/2023 Posts: 6941 Rating: (138)	New question published by Basketballer is split to a separate thread with the subject Can set the breakpoints on almost every functions except one. Best regards Jen_Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards Jen_Moderator
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on