Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Problems with FB on main routine

Created by: ARChan at: 4/5/2012 12:45 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

4/5/2012 12:45 AM	Rate (0)
ARChan Posts: 17 Rating: (0)	Hi! I'm using function blocks for programming a gas detection system. I have six sensors with 0-10V outputs. My ideawas to make a single function block,appropiate for my six sensors,so i could drag and drop it into my main routine six times (one for each sensor) and put them their correspondingsignals. Everything works fine for one sensor, but if I add more of them, mymain routineonly recognizes the values of the first function block. I must mention thatevery time I add the function block I'm writting about, the option multiinstance db doesn´t appear. Could that be my problem?I'm usingTIA PORTAL V11. Thanks! Attachment BLOCKS MAP.jpg (92 Downloads)
ARChan Posts: 17 Rating: (0)
Suggestion To thank Quote Answer

4/5/2012 9:25 PM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 1/27/2023 Posts: 4176 Rating: (1323)	Hi, the multinstance option is just avaliable inside a FB. If you call your sub routines from a OB, this feature is not avaliable. Suggestion, call all blocks from a FB, and this call this FB from OB1.
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

4/14/2012 3:09 PM	Rate (0)
ARChan Posts: 17 Rating: (0)	Thank you so much, Mr. Pegaia. Have a nice day!
ARChan Posts: 17 Rating: (0)
Suggestion To thank Quote Answer

4/16/2012 12:57 PM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 1/27/2023 Posts: 4176 Rating: (1323)	You are welcome. Have a nice day too!
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on