Program is failed when change another version logo

 Thanks you so much! I will try again but I believe that I changed the hardware type to LOGO! 8.FS4. And do you know why another hardware type will make wrong on/off time of Q2 and Q4? Something wrong... I think we just can’t be downloaded when wrong hardware type!?

ixo65

Now I'm confused ...

You write that you want to run this program in a "24RC - 6ED1052-1HB08-0BA0".

This LOGO! but is a LOGO! 8.2. Then, as already written, you have to change the hardware type to LOGO! 8.FS4.

Seeattached video ...

Problem has been resolved. Thanks you so much, sir!

ixo65

Normally there is no problem if you change in LSC the hardware type.

Hello sir,

I very happy because I had been received your help.

I had changed the hardware type, simulation had run exactly. But today, When I use it (0BA0) to connect to my system, error happened again. On/off time of Q2 and Q4 was not true. Then i replaced it by 0BA6, everything is OK. I’m not understand about my problem. Do you have a answer for that? Thanks you. 

ixo65

Hello conmeobeo16,

you're welcome ... 

 I mean I changed hardware type and simulation was exactly but Error happened again when I used it (0BA0) to produce (reality). I dont understand about it. Do you think the length of ethernet cable may be make problem?

Sorry about my english!! 

ixo65

No, in my LOGO!8.2 runs the programm exactly