Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Project S7 300 with TIA V11

Created by: thunder at: 12/14/2013 5:53 AM (3 Replies)

Rating (0)

Thanks 1

4 Entries

12/14/2013 5:53 AM	Rate (0)
thunder Posts: 38 Rating: (0)	Hello everybody! I just installed TIA V11 on my Computer. But in TIA Portal software not support PLC S7 300 and S7 400. I don't understand why. Please help me config again software. Thank you! Attachment error.JPG (248 Downloads)
thunder Posts: 38 Rating: (0)	Last edited by: thunder at: 12/14/2013 5:54 AM
Suggestion To thank Quote Answer

12/14/2013 9:32 AM	Rate (0)
Ganes10 Platinum Member Joined: 8/31/2010 Last visit: 1/9/2025 Posts: 1523 Rating: (230)	thunder Hello everybody! I just installed TIA V11 on my Computer. But in TIA Portal software not support PLC S7 300 and S7 400. I don't understand why. Please help me config again software. Thank you! Hello thunder, It is likely that you have installed STEP 7 Basic v11. (which supports only S7-1200 PLC) You can install STEP 7 Professional v11 / v12(which supports S7-300 PLC)
	Like it? Rate it!
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users thunder

12/14/2013 11:47 AM	Rate (0)
thunder Posts: 38 Rating: (0)	Thank you! I'll try now.
thunder Posts: 38 Rating: (0)
Suggestion To thank Quote Answer

7/21/2014 8:04 PM	Rate (0)
Narrator1 Bronze Member Joined: 3/25/2013 Last visit: 3/21/2019 Posts: 176 Rating: (1)	New question split intoSIMATIC STEP 7 BASIC V12.0 dosn't support CPUs I need. With best regards, Narrator1

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on