Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Replace s120 motor modul on 802D sl

Created by: firmanandrian at: 1/26/2018 5:50 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

1/26/2018 5:50 AM	Rate (0)
firmanandrian Member Joined: 5/19/2015 Last visit: 8/16/2019 Posts: 2 Rating: (0)	Dear Expert We have a CNC machine with use Sinumerik 802D SL with Sinamics S120 Drive Currently one of motor modul was fault (6SL3121-2TE21-0AA3), unfortunately this part number already phase out and replaced with 6SL3121-2TE21-0AA4. My questions are : If we installed new 6SL3121-2TE21-0AA4 on the 802D sl, is it plug and play? If it is not plug and play, how we set the paramater setting for this issue? What software needed for parameter setting motor modul S120 on the 802D SL? can we use starter software? and if you have experience for this could you share the guidance to setup it? Thanks Andri

Suggestion To thank

1/27/2018 12:14 PM	Rate (0)
PISCEAN 2010 Diamond Member Joined: 4/23/2010 Last visit: 1/29/2023 Posts: 7962 Rating: (844)	Please read reply here.

Suggestion To thank

1/29/2018 9:23 AM	Rate (0)
Jen_Moderator Moderator Joined: 6/19/2017 Last visit: 1/27/2023 Posts: 6408 Rating: (125)	Closed cause question posted twice. The second thread with the subject 802D sl is published within the conference SINUMERIK CNC automation Systems. Best regards Jen_Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards Jen_Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on