We can restore backup file

NC, PLC , DRIVER , HMI.

Do we need to adjust importance some parameter ?

...sent from App

S120CF card

 Hello, thanks for this helpful tip.

I have made P9906 = 2 so that the topology warning goes away.

What i dont know what to do is to make the change permanent so that i can change P9906 back to = 1 (high).

In this case i have replaced a 3A Double motor module with a 9A Double motor module but would like to make to project consistent again.

PISCEAN 2010

Object of this TIP

In forum I came across questions related to replacement of Sinamics product with out going on line with STARTER tool. Please refer below procedure to modify parameters while replacing Sinamics S120 components.

P9906 - Topolgy comparison of all components.

0:           High: Compares the complete electronic rating plate. 

1:           Medium: Compares the component type and the article number.

2:           Low: Compares the component type. 

3:           Minimum: Compares the component class. 

The electronic rating plate comprises the following data:

- component type (e.g. "SMC20")

- article number (e.g. "6SL3055-0AA0-5BA0")

- manufacturer (e.g. SIEMENS)

- hardware version (e.g. "A")

- Serial No. (e.g. "T-P30050495")

When comparing the topology, the following data is compared in the target and actual topologies:

p9906 = 0: Component type, Article Number, Hardware version, Manufacturer, Serial No.

p9906 = 1: Component type, Article Number

p9906 = 2: Component type

p9906 = 3: Component class (e.g. Sensor Module or Motor Module)

So when replacing component, check p9906 value, e.g. if want to replace motor module, set p9906 =1, so that motor module serial number would not be comapred after replacement of motor module in actual & target topology.

Another option is check value of p9909.

p9909 = 1, this causes the serial number and the hardware version of the new replaced component is automatically transferred from the actual topology into the target topology and then saved in a non-volatile fashion. Power down the drive, replace the motor module and power back on.A01425 should appear stating that the serial number of the motor module has changed. To clear this warning set p9905 = 1. To clear fault either set p0977 = 1, or preform a copy Ram to Rom and acknowledge.

 p9909 = 0 so that serial numbers and hardware versions are not automatically transferred. Power down the drive, replace the motor module and power back on. A Warning A01425 should appear stating that the serial number of the motor module has changed. To clear this warning set p9905 = 1. p9905 is to transfer serial numbers, this will be stored in the Ram on the drive. To ensure no issues arise a RAM to Rom must be performed. To do this either set p0977 = 1, or preform a copy Ram to Rom in the project.

HTH.

 Thanks, went through the DSS configuration and it seems to have worked.

ChristophD

for this you must modify the project and download it again with the new component

Elecronic gear ratio setting