Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

replacement procedure for CP 342/343 communication modules

Created by: kanan at: 3/7/2011 5:29 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

3/7/2011 5:29 PM	Rate (0)
kanan Posts: 133 Rating: (2)	Dear All. I have problem with replacement of CP module. I replaced module and then downloaded hardware configuration to CPU 315-2DP and faults cleared but I am now can not operate AC motor drives which connected to this CPU via CP. New module taken from another PLC system.both modules are the ssame with only one difference- old one had x/3/4/5 , new one x/5/6/7.Please help. thank you very much. Best regards Kanan
kanan Posts: 133 Rating: (2)	Last edited by: kanan at: 3/7/2011 5:41 PM
Suggestion To thank

3/8/2011 8:28 AM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 11/23/2023 Posts: 2683 Rating: (135)	Thread closed, because question is already published in the following thread CP card 342/343 replacemennt problem. Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on