Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Replacing wago IO with siemens

Created by: JJ99 at: 8/20/2020 6:33 AM (6 Replies)

Rating (0)

Thanks 1

7 Entries

8/20/2020 6:33 AM	Rate (0)
JJ99 Posts: 83 Rating: (0)	Hi All, What are the steps of replacing WAGO Digital Input and Analog Output with Siemens IO modules? Thanks
JJ99 Posts: 83 Rating: (0)
Suggestion To thank Quote Answer

8/20/2020 8:18 AM	Rate (0)
Madadi Bronze Member Joined: 12/28/2016 Last visit: 6/6/2023 Posts: 372 Rating: (42)	سلام What is your CPU order number?
	https://pnap.ir If this Information really helps, you could use the Rate function😉
Suggestion To thank Quote Answer

8/20/2020 8:30 AM	Rate (0)
JJ99 Posts: 83 Rating: (0)	CPU 414-2DP with CP 443-1
JJ99 Posts: 83 Rating: (0)
Suggestion To thank Quote Answer

8/20/2020 12:43 PM	Rate (0)
Madadi Bronze Member Joined: 12/28/2016 Last visit: 6/6/2023 Posts: 372 Rating: (42)	You can use a WAGO interface module to connect the WAGO modules to the simens cpu via the profile bus network. To define this module in step7 you need a GSD file. Fieldbus Coupler PROFIBUS DP
	https://pnap.ir If this Information really helps, you could use the Rate function😉
Suggestion To thank Quote Answer

8/20/2020 12:54 PM	Rate (0)
Madadi Bronze Member Joined: 12/28/2016 Last visit: 6/6/2023 Posts: 372 Rating: (42)	JL99 Hi All, What are the steps of replacing WAGO Digital Input and Analog Output with Siemens IO modules? Thanks I did not understand you. Do you want to remove WAGO modules and use Siemens modules? In this case you can do this using IM153-1 6ES7153-1AA03-0XB0 This can be easily done in step7 software
	Last edited by: Madadi at: 08/20/2020 13:03:00 https://pnap.ir If this Information really helps, you could use the Rate function😉
Suggestion To thank Quote Answer

8/21/2020 2:36 AM	Rate (0)
JJ99 Posts: 83 Rating: (0)	Hi Madadi, Thanks for your response. That'sRight. I want to replace wago with siemens. Any changes to be made in software side? Apart from Addressing.
JJ99 Posts: 83 Rating: (0)
Suggestion To thank Quote Answer

8/22/2020 4:06 PM	Rate (0)
Madadi Bronze Member Joined: 12/28/2016 Last visit: 6/6/2023 Posts: 372 Rating: (42)	If the input and output addresses do not change, no, there is no need to change the software and you just need to change the hardware configuration. But if you have to choose different input and output addresses, these addresses must be replaced in the software.
	https://pnap.ir If this Information really helps, you could use the Rate function😉
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users JJ99

|

Share this page:

Share this page on...

Follow us on