Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

RFID Moby D

Created by: amrmabrouk at: 6/18/2010 9:22 AM (6 Replies)

Rating (0)

Thanks 0

7 Entries

6/18/2010 9:22 AM	Rate (0)
amrmabrouk Posts: 13 Rating: (0)	Dear all I was reading the example https://support.automation.siemens.com/WW/llisapi.dll?func=cslib.csinfo&objid=34677186&lang=en&cspltfrm=0&cssw=0&csbinh=8 I understand most of it,But I can't get what are the sequence of commands needed to write or read data to and from the MDS. I have the required hardware for this example I already ran it.But i want to know how to read and write to the MDS Please help Thanks in advance
amrmabrouk Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

6/18/2010 10:04 AM	Rate (0)
Bilao Posts: 378 Rating: (47)	Hello, i can´t really help you. But for the other users, i think he is talking about this entry http://support.automation.siemens.com/WW/view/en/24621867 Best regards Bilao
Bilao Posts: 378 Rating: (47)
Suggestion To thank Quote Answer

6/18/2010 10:14 AM	Rate (0)
amrmabrouk Posts: 13 Rating: (0)	yes this is the link sorry for the wrong one I posted first please help regards amr
amrmabrouk Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

6/18/2010 11:08 AM	Rate (0)
miami Platinum Member Joined: 8/31/2005 Last visit: 1/20/2025 Posts: 2198 Rating: (330)	amrmabrouk But i want to know how to read and write to the MDS Did you already look into the FB45 manual (chapter 3.2) ?

Suggestion To thank Quote Answer

6/18/2010 11:34 AM	Rate (0)
amrmabrouk Posts: 13 Rating: (0)	I read it now, so correct me if I am wrong you call fb45,associate a DB with it,withtin this DB you have UDT10,UDT20 where you set the command you want what other variables are in the DB? thanks for your help
amrmabrouk Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

7/6/2010 5:24 PM	Rate (0)
miami Platinum Member Joined: 8/31/2005 Last visit: 1/20/2025 Posts: 2198 Rating: (330)	I have no experience with it , but: Yes, I think it is so.

Suggestion To thank Quote Answer

12/13/2010 3:45 PM	Rate (0)
seb_nancy Posts: 37 Rating: (0)	Yes, you have two DBs to use with the FC Moby UDT Command and UDT Parameters You can configure : The adresse of the ASM The channel number of the ASM Start adress of the DB command Start adress in MDS MDS_control ECC_mode reset function MOBY mode Scanning Time
seb_nancy Posts: 37 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on