Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

RTD i/p module 6ES7 134-4jb51-0ab0 - is it necessary to short-circuit unused inputs

Created by: kartikkapta at: 7/1/2014 10:14 PM (4 Replies)

Rating (0)

Thanks 1

5 Entries

7/1/2014 10:14 PM	Rate (0)
kartikkapta Posts: 7 Rating: (0)	hello experts, i am using RTD i/p module 6ES7 134-4jb51-0ab0. so i want to know that ...is it necessary to short-circuit unused inputs...and if yes then how? and without short-circuiting of unused inputs...it gives -32767 value in simatic ...so please any one can help me about this..??
kartikkapta Posts: 7 Rating: (0)	Last edited by: Narrator1 at: 7/2/2014 8:21 PM Topic split from /tf/WW/en/Posts/38990#top
Suggestion To thank Quote Answer

7/1/2014 11:07 PM	Rate (0)
kartikkapta Posts: 7 Rating: (0)	hello experts, i am using RTD i/p module 6ES7 134-4jb51-0ab0. i used to connect 3 wire RTD with it... so i want to know that ...is it necessary to short-circuit unused inputs...and if yes then how? and without short-circuiting of unused inputs...it gives -32767 value in simatic ...so please any one can help me about this..??
kartikkapta Posts: 7 Rating: (0)	Last edited by: kartikkapta at: 7/1/2014 11:15 PM
Suggestion To thank Quote Answer

7/2/2014 7:39 AM	Rate (0)
Marcjan Platinum Expert Joined: 4/22/2010 Last visit: 5/3/2024 Posts: 5697 Rating: (715)	Hello, The manual is pretty clear about it. page 29: 5.2 Wiring unused channels on analog input modules Rules Pay attention to the following instructions when wiring unused channels: ● "Disable" unused input channels when setting parameters. ● A disabled channel always returns the value 7FFFH. ● The cycle time of the module reduces by 80 ms (e.g. 84 ms) per disabled channel. ● To adhere to the permissible potential differences, you must wire jumpers on the terminal module for the unused channels. Regards, Marcjan
	Problem solved? Please let us know! Please no technical questions by PM, use the forum sections for your questions.
Suggestion To thank Quote Answer

7/2/2014 6:20 PM	Rate (0)
kartikkapta Posts: 7 Rating: (0)	Thank you so much Mr.marcjan ....problem is solved..
kartikkapta Posts: 7 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Marcjan

12/15/2017 12:19 PM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (172)	New question published by Acti is split to a separate thread with the subject RTD i/p module 6ES7 134-4jb51-0ab0 - How can read the values for 4 input?. Best regards Jen_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on