Dear all,

I bought a serial switch module for my RX1500 device (6GK6015-0AL20-0KB0 / RX1500PN-S01).

I configured the baud-rate / parity / Port-Type... of the three serial interface I will use. But I  would like to be sure on the capability of this module for my application.

I would like to use the Port 1 for a master RS232 device which will poll the port 2 by default and switch to port 3 in case of communication failure. Is it possible to configure the device accordingly?

If not, is it at least possible to use port 1 and port 2 and have the same behavior as a direct serial RS232 communication? 

Thanks for your support,

Regards,  

Cédric

New question published by stevenhargraves1 is split to a separate thread with the subject Configuration of RX1500.

Best regards
Jen_Moderator