HI

I am configuring my HMI (KTP600 Basic) to show an alarm which will be triggered via modbus through a bit, so the alarm is going to be a symbol and that symbol should only be visible on the screen when the alarm bit it true. what i am stuck with now is in the dynamic visibility option menu, i can't select the single bit option instead i can only use the bit range option. Any idea why ???

picture attached. and thanks in advance

Single bit option is not enabled, even though you use Bool or Int Tag. Like mentioned before if you put in Range both 1 it shuld work.

Have tried with Simulation with tag simulator, it should work with it. If you are using real hardware then programming or communication should be the problem.

New question published by ted.atman is split to a separate thread with the subject Get Software for S7-1200.

Best regards
Min_Moderator

syd_b

Single bit option is not enabled, even though you use Bool or Int Tag. Like mentioned before if you put in Range both 1 it shuld work.

Have tried with Simulation with tag simulator, it should work with it. If you are using real hardware then programming or communication should be the problem.

 By not enabled... do you mean that there is a way to enable the single bit option ?.