S120 Commisioning

Hi,

I want  commissioning S120

But I have a some problem

Refer below the picture

I want to add the drive to the right  like in the picture

But I couldn't

What do I do ?

Pls Let me know

Thanks

TechTeam

Hello,

when you want to connect an S120 drive to the technology object of the PLC, you first need to select a suitable telegram on the drive (e.g. telegram 105 etc.). Then it will be shown in the connection wizard of the technology object. The telegram configuration can be found on the S120 side by clicking on the Control Unit in the device view of the S120. In the properties of the CU -> Profinet port you find the cyclic data exchange with the telegram settings for all drive objects.

 Hi,

I did it

But I have a some problem

The telegram configuration have done

So Driver is appeared

But I couldn't select it

Refer in the picture

Thanks

ChristophD

Hello,

expand the three of the Profinet system in the left windows, navigate to the sinamics then in the right windows the connectable drives are displayed.

But this only if you configure it! Have you configure the drive(Motormodule/Sensormodules/encoders)?

Regards

Christoph

 Thanks

New question published by Zyad is split to a separate thread with the subject Want to replace motor module S120 - What's the steps which can be done to define him on control unit 320?.

Best regards
Jen_Moderator