Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

s120 p2572 and p2573 maximum limit doubt

Created by: dhinagaran at: 1/17/2014 1:54 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

1/17/2014 1:54 PM	Rate (0)
dhinagaran Experienced Member Joined: 5/12/2011 Last visit: 8/21/2024 Posts: 78 Rating: (1)	dear all, S120 drive used for vertical axis posistion control, drive programmed already they kept p2572 = 8000 and p2573 = 1000, now while checking auto operation drive went with very very high speed from top to bottom and hitted the componenet. so please sombody conform how much maximum value we can keep in above parameters is there any efect by this parameter for this overspeed problem. other parameter looks ok. regards, v. dhinagaran.

Suggestion To thank Quote Answer

1/19/2014 9:31 PM	Rate (0)
zako_ Gold Member Joined: 5/22/2012 Last visit: 3/24/2022 Posts: 895 Rating: (67)	... what are your mechanic settings and what`s the rated speed of your motor (which motor do you use)?

Suggestion To thank Quote Answer

1/22/2014 11:39 AM	Rate (0)
dhinagaran Experienced Member Joined: 5/12/2011 Last visit: 8/21/2024 Posts: 78 Rating: (1)	dear zako, motor type: 1FK7 synchronous motor rpm: 3000.0rpm torque: 4.70nm amps: 3.7amps Rated motor power: 1.48kw. i am using basic posistion controller with closed loop speed control method. even if you say why we need to increase this parameters i will be happy... regards, v. dhinagaran.
	Last edited by: dhinagaran.v at: 1/22/2014 11:43 AM Last edited by: dhinagaran.v at: 1/22/2014 11:42 AM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on