Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S120 s7-1500

Created by: seb02880 at: 6/8/2016 8:21 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

6/8/2016 8:21 AM	Rate (0)
seb02880 Member Joined: 6/7/2016 Last visit: 8/8/2023 Posts: 1 Rating: (0)	Hello, We start a new setup for educationnal experimental work. It consists of a s7-1500 and a sinamic s120 with a servomotor connected throught profinet. Whith starter software, the set up works perfectly. It is well regulated either in position or speed. But under tia porta, it seems impossible to unlock the motor in the test panel when connected to the system. Nevertheless, the configuration seems ok why al lights are green. Do you have any idea why it is not working? Cordialy

Suggestion To thank Quote Answer

6/8/2016 10:05 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 10/16/2024 Posts: 22414 Rating: (3018)	Hello, do you mean the Control Panel of the Axis in TIA? Which error you get? Any RED LED blinking on S7-1500 or S120 ? Any fault pressent on the Drive (Check it with Starter online). Do you use the right GSDML for the S120 in TIA and configure the Axis Settings correctly? Regards Christoph

Suggestion To thank Quote Answer

6/30/2016 11:36 AM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by AutoGen_410306 is split to a separate thread with the subject communicatione between S7-1500 and S120. Best regards Min_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on