Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S5 210-A

Created by: FADATAMO at: 7/3/2011 10:37 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

7/3/2011 10:37 PM	Rate (0)
FADATAMO Regular Member Joined: 3/21/2011 Last visit: 12/15/2021 Posts: 5 Rating: (0)	I need to know about the software for programming the S5-210A microcomputer system. I have a DB9 male connector with TTY interface, but I do not know the conection to computer. Help me splitted from the german spoken thread S5 210-A
	Last edited by: CS Moderator at: 7/4/2011 9:21 AM question splitted
Suggestion To thank Quote Answer

7/4/2011 10:05 AM	Rate (0)
Azteke0110 Posts: 376 Rating: (57)	Hello, Excuse but this is everything what I have found to this system. The PLC S5 210-A, is an linear programmed PLC, which have only one Block (P1) and no Segments. This PLC and its EPROM-Modul is only readable and programmable with PG631 or PG670. Unfortunately, I cannot help you. I have never worked with this system. I hope somebody still reports. Best regards Gucci
Azteke0110 Posts: 376 Rating: (57)
Suggestion To thank Quote Answer

7/20/2011 3:06 AM	Rate (0)
FADATAMO Regular Member Joined: 3/21/2011 Last visit: 12/15/2021 Posts: 5 Rating: (0)	Hello, In the system S5-210A I have a central controller S5-210A III (6ES5 210-2AL11) with a power supply 6ES5 955-3LC13, also I have a CPU 928 (6ES5 928-3UA21) from the S5-135U/S5-155U. I need to know, if it is possible to connect the CPU928 in the central controller S5-210A and reused the I/O installed in the central controller. Regards, FADATAMO

Suggestion To thank Quote Answer

7/20/2011 4:47 PM	Rate (0)
Azteke0110 Posts: 376 Rating: (57)	Hello Fadatamo, please excuse, but unfortunately I have not ananswer for your question. I try to investigate. But I cannot promise a solution. Best regards Gucci
Azteke0110 Posts: 376 Rating: (57)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on