Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

s7-1200 PWM control

Created by: celales at: 8/27/2013 9:50 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

8/27/2013 9:50 AM	Rate (0)
celales Posts: 1 Rating: (0)	Hi...i am new at this...i want to learn how to control my PWM...i have inserted a CTRL_PWM next to my Block_1_DB in main...i wish to know what do i put in (PWM,ENABLE,BUSY,STATUS)...and were do i control the speed of my engine...and also were do i put the Q that i wish to control...these are probably dumb questions but i repeat i am still in the learning stage
celales Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

8/27/2013 12:52 PM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 12/26/2024 Posts: 4376 Rating: (1458)	Hi, you can define the properties of PWM in the Device View (configuration). Once did, you can move values directly(e.g QW100).
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

3/2/2016 11:01 AM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by engco is split to a separate thread with the subject How to use the PWM in the program after creating it?. Best regards Min_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on