Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S7-400 and ControlLogix 5555

Created by: Ruffo at: 4/23/2007 7:39 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

4/23/2007 7:39 PM	Rate (0)
Ruffo Posts: 5 Rating: (0)	Hi, I need to comunicate a S7-400 and a Controllogix 5555 using Ethernet, so far a know I will need a gateway, can someone help me on this? thanks in advance Christian
Ruffo Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

4/24/2007 12:45 AM	Rate (0)
KLooPY Posts: 38 Rating: (5)	Hi Ruffo if the ethernet module for the s7 400 is the same as for the s7 200, you will need the CP243-1 module, please check that in the manual Hope this helps Kloopy
KLooPY Posts: 38 Rating: (5)
Suggestion To thank Quote Answer

4/24/2007 9:53 AM	Rate (0)
J_Bell Posts: 5822 Rating: (411)	Hello, I am sorry but the Ethernet CP for the S7-400 is not the same as for the S7-200. The Ethernet Interfaces for the S7-400 are: CP 443-1 Internal PROFINET Interface. For the link to the ControlLogix5555 you can use some Gateways, one of it is: ANYBUS X; Anybus-X - Ethernet / IP Slave- PROFINET I/O I hope I could help. Best regards J_Bell
J_Bell Posts: 5822 Rating: (411)
Suggestion To thank Quote Answer

4/24/2007 4:42 PM	Rate (0)
Ruffo Posts: 5 Rating: (0)	Thanks, looks like that my research wasn't good at all . Yersterday I found a Siemens document ID:23901499, that says that I can use a gateway named Echochange . I hope it works!!! Christian Attachment 23901499_Echochange-Gateway_DOKU_V10_e.pdf (330 Downloads)
Ruffo Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on