Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S7: ftp data transmission

Created by: bunglehead at: 11/29/2007 12:54 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

11/29/2007 12:54 AM	Rate (0)
bunglehead Posts: 54 Rating: (3)	Hello, I need an ability to test my application that used ftp functions of Advanced IT CPs. Is it possible with WinAC (without SLOT PLC of course)or any other simulation software?
bunglehead Posts: 54 Rating: (3)
Suggestion To thank Quote Answer

11/29/2007 3:51 AM	Rate (0)
Dec Gold Expert Joined: 5/19/2006 Last visit: 12/3/2024 Posts: 549 Rating: (107)	Hello, There is no such an ability to simulate/test ftp transfer with either WinAC or PLCSim as far as I know. Dec

Suggestion To thank Quote Answer

11/29/2007 7:50 AM	Rate (0)
bunglehead Posts: 54 Rating: (3)	It's vary bad..(..Hope it'll change sometimes..I couldn't wait for CP delivery to start developing
bunglehead Posts: 54 Rating: (3)
Suggestion To thank Quote Answer

12/1/2007 12:07 AM	Rate (0)
J_Bell Posts: 5822 Rating: (412)	Hello, I do not get your point, you can develop, you just can not use or test your developed Code... thats all. The thing is... if you want to have IT functionality you may also need some FM or other CP too... what else shouldbe added toa simulation Software? Best regards. J_Bell
J_Bell Posts: 5822 Rating: (412)
Suggestion To thank Quote Answer

12/1/2007 9:14 PM	Rate (0)
bunglehead Posts: 54 Rating: (3)	)) I can't develop without testing, cause I want to use this ftp functionality as a key task of mass data transfer in the system. And I can assure you that a factory will not wait my interface changes if something goes not as I expected during developing. So testing on factory which is often working in manual mode isn't a good solution))
bunglehead Posts: 54 Rating: (3)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on