Hello

I bought W720/W760 Scalance access point and client. I want to connect one PLC s7-1200 to the AP and one s7-1200 to client. I am using tia portal v13 sp1 upd 9

The problem is that in SCALANCE i have a firmware 6.1 whereas in Tia Portal i have version 5.2 of SCALANCE

The only package of isp files with scalance that I found :

https://support.industry.siemens.com/cs/document/72341852/support-packages-for-the-hardware-catalog-in-the-tia-portal-(hsp)?dti=0&lc=en-WW

Unfortunetaly there is no 6.1 version the "newest" available version in this packet is 5.2

Is there any link to 6.1 version of .isp13 file? Does it exist on TIA PORTAL v13 at all?

Hello,

It is not mandatory to put the AP and the Client in the project.
You can administer the AP and the client Web based, and put the wireless into operation without any TIA project at all.
You just surf to the IP address of the AP and the client using a standard browser and run trough the wizards in the Web based management.
To set the IP address of the AP and the Client, you can use either the primary setup tool delivered on the CD that was with the devices (or you can download it here: https://support.industry.siemens.com/cs/de/en/view/19440762).

Thank you for answer.

I managed to overcome this Problem :)

[snip]

New question published by DamianMD is split to a separate thread with the subject Send data between the drivers - What configuration of network shall i set in Tia Portal?.

Best regards
Jen_Moderator