Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Screen Off

Created by: A.T.A at: 10/17/2009 5:09 AM (5 Replies)

Rating (0)

Thanks 0

6 Entries

10/17/2009 5:09 AM	Rate (0)
A.T.A Posts: 24 Rating: (0)	Hi. Working an inexperiented person with sysem(SINUMERIK 840D,OP012), Whenstarts up HMI Advanced the screen turns off after 2 second and it doesn't turn on. I bring the control system into a defined initial state (NCK general reset) but problem didn't solve. How can i solve it? Thanks a lot.
A.T.A Posts: 24 Rating: (0)
Suggestion To thank Quote Answer

10/17/2009 9:57 AM	Rate (0)
Gebhardt Karl Platinum Expert Joined: 7/16/2006 Last visit: 1/2/2024 Posts: 1502 Rating: (176)	Hi I think, you have a PCU-Problem. For test --> Remove the violet Cable from PCU/MMC. After startup an Error "No PLC/NC Connection" or "SO" must be see in the OP12. Testit and answer here.
	Karl
Suggestion To thank Quote Answer

10/17/2009 10:00 AM	Rate (0)
Gebhardt Karl Platinum Expert Joined: 7/16/2006 Last visit: 1/2/2024 Posts: 1502 Rating: (176)	Hi What Power do you have an PCU ? 24 Volt DC (+-10%) ? Can you give an external Power for Test ? (Separate Power-Unit)
	Karl
Suggestion To thank Quote Answer

10/17/2009 1:13 PM	Rate (0)
A.T.A Posts: 24 Rating: (0)	Hi. I do your test and yor are right(I see this error:Waiting for a connection to the NC/PLC) and now ... Thanks a lot.
A.T.A Posts: 24 Rating: (0)
Suggestion To thank Quote Answer

10/17/2009 3:02 PM	Rate (0)
Gebhardt Karl Platinum Expert Joined: 7/16/2006 Last visit: 1/2/2024 Posts: 1502 Rating: (176)	Hi. >I do your test and yor are right(I see this error:Waiting for a connection to the NC/PLC) O.K. Your PCU are is working fine. >and now ... For Information: Now I think you have "bad Information" from NC or PLC. NOW: Startup your System without MPI-Cable (violet-Cable in your PCU). Wait 4-6 Minute. Connect your Cable. Try to clear the Errors. With your MSTT "Reset" an "Big Mag" button. Do you have now the Connection with PLC and NC ? ( No character "#" see an the PCU.) (Position for the Axisare O.K.) Then next Step. If work this moment, you can try save NC and PLCMain-Programms Datas.
	Karl
Suggestion To thank Quote Answer

10/19/2009 4:54 AM	Rate (0)
A.T.A Posts: 24 Rating: (0)	Thanks for your help. Two thing chaned. Terminator resistor has been off for MCP and DIP switch S3 has been changed for MCP. Thanks a lot.
A.T.A Posts: 24 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on