Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Screen saver in MMC-100 and MMC-103

Created by: Controls_Engineer at: 8/18/2011 3:48 PM (6 Replies)

Rating (0)

Thanks 0

7 Entries

8/18/2011 3:48 PM	Rate (0)
Controls_Engineer Posts: 60 Rating: (1)	How to enable screen saver in MMC-100 and MMC-103 to increase TFT backlight life?? Thanks, Venki
Controls_Engineer Posts: 60 Rating: (1)
Suggestion To thank Quote Answer

8/19/2011 7:26 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (482)	Hello.... MMC series have the OP with LCD sereis only not with TFT. MD 9006 (for MMC100):In this MD you set the time after which the screen saver is to be activated. The screen saver is activated if none of the keys on the operator panel have been pressed within the specified time. Regards, Prakash
Ekalavya Posts: 2964 Rating: (482)
Suggestion To thank Quote Answer

8/19/2011 7:37 AM	Rate (0)
Controls_Engineer Posts: 60 Rating: (1)	Dear Prakash, thanks for your reply. I have set the screen saver in MMC100 by adjusting MD9006. But in MMC103 (6FC5210-ODA20-2AA1) i am not able to access the MD9006. In Start up - Machine data - Display screen Md9006 not displayed. How to access it?? Thanks
Controls_Engineer Posts: 60 Rating: (1)
Suggestion To thank Quote Answer

8/19/2011 7:41 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (482)	Hello... I have the information pcu50...may be this also works in MMC103....check it out.... you need to boot in windows mode and search the below The delay time before the screen saver is activated can be adjusted: Section: GLOBAL Entry : MMCScreenOffTimeInMinutes Notice The HMI screen saver and Windows screen saver must not be used at the same time. • HMI screen saver: protection for screen and backlight • Windows screen saver: protection for screen only (blank screen) Regards, Prakash
Ekalavya Posts: 2964 Rating: (482)
Suggestion To thank Quote Answer

8/19/2011 8:44 AM	Rate (0)
Controls_Engineer Posts: 60 Rating: (1)	How to access section GLOBAL ??
Controls_Engineer Posts: 60 Rating: (1)
Suggestion To thank Quote Answer

8/19/2011 11:21 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (482)	Venki-Controls How to access section GLOBAL ?? Hello.... Boot the MMC103 in Windows mode.....after this locate the folder > MMC2> mmc.ini > 1st information itself is GLOBAL in this you can find the information.... Regards, Prakash
Ekalavya Posts: 2964 Rating: (482)
Suggestion To thank Quote Answer

8/22/2011 10:23 AM	Rate (0)
Controls_Engineer Posts: 60 Rating: (1)	Here i am attacing mmc.ini file for your reference. In this i am not able to find required information. Awaiting for your reply. Thx Attachment mmc.zip (91 Downloads)
Controls_Engineer Posts: 60 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on