Ayman Elotaify

Hello again,
Looks like that Siemens wanted to make it easier!
I have just found a pre-made face plates libraries you can use in WinCC for Sentron PAC-3200.
Please have a look on the following link:
System Manual Library SENTRON PAC3200 for SIMATIC WinCC

 hello mr. Ayman 

i connected sentron pac 3200 to wincc and it is ok , but when i run it on two computers it run on one device only.

------------------------------------------------------------------------------------------
Split from Sentron PAC3200.

Closed cause question posted twice.

The second thread with the subject Need help to connect sentron PAC 3200 to 2PCs over scada is published within the conference Communication / Networks.

Best regards
Jen_Moderator