Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

sequence of events in wincc

Created by: karn at: 4/20/2009 3:35 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

4/20/2009 3:35 PM	Rate (0)
karn Posts: 25 Rating: (0)	Dear all, I have to achieve 10ms timestampping with ET200M modules. I am using following modules.-S7400(CPU 414-2DP),CP443-1(Ethernet Card),ET200M(6ES7153-2BA02-0XA0) with DI (6ES7321 7BH01 0AB0). I configured this system using FB62 and in this block i am able to store messages till 15numbers. Now my question is how do you see in WINCC.how should we program this in WINCCto see these timestamps. I tried using alarm logging table but i am not able to see any fast 10ms input signal in wincc. When we open the instance DB of FB62 i see all the timestamps are not recorded in sequential manner. Please help me out. Any project back up of storing timestamps into wincc will help me out. bye karn
karn Posts: 25 Rating: (0)
Suggestion To thank Quote Answer

4/21/2009 5:01 PM	Rate (0)
cumulus Platinum Member Joined: 9/27/2007 Last visit: 12/18/2020 Posts: 993 Rating: (102)	Hi try the demo of this http://support.automation.siemens.com/WW/view/en/20614217 This should help regards cumulus
	Learn more about visualization - visit the HMI courses of Siemens AG! siemens.com/sitrain Basic course WinCC (TIA Portal) machine-based https://support.industry.siemens.com/cs/ww/en/view/109758624 Advanced course WinCC (TIA Portal) machine-based https://support.industry.siemens.com/cs/ww/en/view/109758626 Basic course WinCC Professional https://support.industry.siemens.com/cs/ww/en/view/109758618 Basic course SiVArc (Auto. Generation of HMIs) https://support.industry.siemens.com/cs/ww/en/view/109758628 Basic course Energy Suite https://support.industry.siemens.com/cs/ww/en/view/109755577
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on