Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

"Set slave address" not editable addresses

Created by: lean at: 4/6/2013 1:30 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/6/2013 1:30 PM	Rate (0)
lean Regular Member Joined: 11/13/2009 Last visit: 1/9/2023 Posts: 19 Rating: (0)	Hello. I have an econder "Temposonic" connected to the profibus network. Its profibus address can only be change by a "set slave address" function or a programmer device that I dont have. When I run the service SSA(set slave address) it shows me a window with two fields, one is actual address and another is the new address. The problem is this fields come out with a fix value and Im not able to edit them to put the addresses I want. If I accept this fix value it changes the address of the encoder but not to the desire one. For example the default address of the encoder was 125 and I want to set 22, so when I run the SSA it shows me Actual=125, New=3, but not editable. So I apply and get addres 3 on the encoder, that part works. I attach a screen shot(sorry it is in spanish) By the way Im using a CP5711 to connect my Laptop to profibus. Regards Attachment TemposonicDP - Copy.jpg (185 Downloads)

Suggestion To thank Quote Answer

4/6/2013 4:19 PM	Rate (0)
Marko Bursic Platinum Member Joined: 9/8/2009 Last visit: 3/15/2023 Posts: 1410 Rating: (148)	IMO, you should ask this question to encoder producer.

Suggestion To thank Quote Answer

8/19/2015 10:48 AM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4812 Rating: (123)	New question published by Shipon is split to a separate thread with the subject Assign profibus node address. Best regards Min_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on